Stop throwing away money on wipes
Tell us about your studio and we’ll show you how much you can save.
Here is a calculator for how much you can save with OPTIM OS1 wipes
Save Money
Offices using Quats-alcohol-based wipes that switch to OPTIM OS1 can save over $2,000 per year on average.
Shorten Turn Over Time
A hospital-grade cleaner-disinfectant with 60-second kill times for the toughest viruses, bacteria, and yeast, and 45 seconds for TB.
Reduce Wipe Waste
Wipe down the same surface area that would take two competitor wipes to complete effectively.
How they tested it.
In a recent Dental Advisor study² on surface disinfectant wipes, OPTIM OS1 outperformed the other brands, including a leading quats-alcohol wipe. Not only did it remain effective for its full 1-minute contact time, but it also covered a much larger surface area than the competitor wipes.
To test the wipes, researchers used a 12.5-square-foot table divided into four sections. Each wipe was used to wipe down one quarter section. Researchers then waited for the kill time to elapse before moving to the next section with the same wipe. OPTIM OS1 was able to effectively clean and disinfect two times more surface area than the leading quats-alcohol-based wipe.
Statim Water Pump Filters removed and inline filter added
Effective June 2007 SciCan removed the two filters located on each end of the water pump due to the implementation of the water reservoir filter in early 2006. In the past, when the water reservoir filter was not present, debris and dust that entered the reservoir had a chance of getting into the water pump. The two filters in the water pump fittings were required to catch this debris.
Since the water reservoir filter has been implemented in early 2006 (refer to 05-TSB-204), SciCan has decided to remove these unnecessary filters in the water pump and discontinue the replacement parts for these filters, 01-104501S (Filters Pump A/B/C/D), as they are no longer required once the water reservoir filter is installed.
Removal of these filters does not affect the operation of the Statim units in any way.
Water pump maintenance
1. Ensure a water reservoir filter is installed
a. New reservoir filter and reservoir cap (01-101783S)
b. Replacement reservoir filter (01-109300S)
2. Inspect and clean the water pump filters, if the machine is equipped with them
A replacement elbow fitting without an outlet filter is available as part # 01-111115S if the filtered fitting (shown above) becomes damaged beyond use.
Addition of In-line filter
In December 2007 an in-line filter was added between the water reservoir and the water pump inlet to address the issue of customers not using the reservoir filter. The purpose of this in-line filter is to stop debris from entering the Statim plumbing system when the reservoir filter is not used.
The in-line filter kit is available as part # 01-106637S and includes the filter and all necessary tubing. This filter should be replaced every 2000 cycles or every two years.
