Stop throwing away money on wipes
Tell us about your studio and we’ll show you how much you can save.
Here is a calculator for how much you can save with OPTIM OS1 wipes
Save Money
Offices using Quats-alcohol-based wipes that switch to OPTIM OS1 can save over $2,000 per year on average.
Shorten Turn Over Time
A hospital-grade cleaner-disinfectant with 60-second kill times for the toughest viruses, bacteria, and yeast, and 45 seconds for TB.
Reduce Wipe Waste
Wipe down the same surface area that would take two competitor wipes to complete effectively.
How they tested it.
In a recent Dental Advisor study² on surface disinfectant wipes, OPTIM OS1 outperformed the other brands, including a leading quats-alcohol wipe. Not only did it remain effective for its full 1-minute contact time, but it also covered a much larger surface area than the competitor wipes.
To test the wipes, researchers used a 12.5-square-foot table divided into four sections. Each wipe was used to wipe down one quarter section. Researchers then waited for the kill time to elapse before moving to the next section with the same wipe. OPTIM OS1 was able to effectively clean and disinfect two times more surface area than the leading quats-alcohol-based wipe.
Anodic Paintbrush Leads
Paintbrush Lead Kit, 1 of each of the 4 sizes
The easy way to create your own masterpieces!
Just plug in the lead to the black jack on your anodizer, dip into electrolyte and "paint" on your niobium or titanium that has been clipped to your red (anode) lead.
Heavy duty wire soldered to the ferrule and covered with a thick adhesive shrink tube will ensure years of problem free painting.
7-8" brush with a 24" cord.
INSTRUCTIONS
- Plug your paintbrush lead into the black jack (cathode) on your anodizer.
- Attach the red lead (anode) to your piece.
- Dip paintbrush into your electrolyte and slowly turn up the voltage on your anodizer.
⚠️⚡It is not advisable to turn the voltage up high and touch your piece with the paintbrush lead. This can damage your lead as well as your anodizer. Start low, keeping the brush saturated with electrolyte and turn up the voltage slowly.
⚠️⚡Do NOT let your bristles dry out or touch the ferrule to your metal. Doing so can melt your bristles and/or cause burn marks on your metal. All warranties will be voided if damage occurs due to dry brush or ferrule contact with metal.
