Stop throwing away money on wipes
Tell us about your studio and we’ll show you how much you can save.
Here is a calculator for how much you can save with OPTIM OS1 wipes
Save Money
Offices using Quats-alcohol-based wipes that switch to OPTIM OS1 can save over $2,000 per year on average.
Shorten Turn Over Time
A hospital-grade cleaner-disinfectant with 60-second kill times for the toughest viruses, bacteria, and yeast, and 45 seconds for TB.
Reduce Wipe Waste
Wipe down the same surface area that would take two competitor wipes to complete effectively.
How they tested it.
In a recent Dental Advisor study² on surface disinfectant wipes, OPTIM OS1 outperformed the other brands, including a leading quats-alcohol wipe. Not only did it remain effective for its full 1-minute contact time, but it also covered a much larger surface area than the competitor wipes.
To test the wipes, researchers used a 12.5-square-foot table divided into four sections. Each wipe was used to wipe down one quarter section. Researchers then waited for the kill time to elapse before moving to the next section with the same wipe. OPTIM OS1 was able to effectively clean and disinfect two times more surface area than the leading quats-alcohol-based wipe.
Anodic Marker Lead
Just fill the marker with electrolyte using the included dropper. Depress the tip to release the electrolyte. Too much? Dab on a paper towel. Too little? Depress again.
Use on niobium or titanium that has been clipped to your red (anode) lead.
Replacement 2mm tips available.
Ships with plastic dropper.
5" marker with a 28" cord.
Developed in partnership with Reactive Metals Studio Inc by John S. Miller.
2mm Anodic Marker Lead $39.95 each
INSTRUCTIONS
- Remove the stopper from the end of the marker.
- Using the supplied dropper, fill marker with electrolyte.
- Replace stopper firmly using a twist motion.
- Plug lead into the black (cathode) jack on your anodizer.
- Holding upright, depress tip end of marker until it becomes wet with electrolyte. Avoid flooding the tip-if there is too much liquid just blot on a paper towel.
⚠️⚡It is not advisable to turn the voltage up high and touch your piece with the marker. This can damage your marker as well as your anodizer. Start low, keeping the tip saturated with electrolyte and turn up the voltage slowly.
⚠️⚡Do NOT let the tip dry out as burn marks can occur on the metal if tip is too dry. Tips can be removed and the alternate end used once first end has become worn.
⚠️⚡Do NOT pull the lead out of jack by the cord, hold on to the banana plug when removing. By using this item, you agree to assume all risks and responsibilities associated with its use.
