Stop throwing away money on wipes
Tell us about your studio and we’ll show you how much you can save.
Here is a calculator for how much you can save with OPTIM OS1 wipes
Save Money
Offices using Quats-alcohol-based wipes that switch to OPTIM OS1 can save over $2,000 per year on average.
Shorten Turn Over Time
A hospital-grade cleaner-disinfectant with 60-second kill times for the toughest viruses, bacteria, and yeast, and 45 seconds for TB.
Reduce Wipe Waste
Wipe down the same surface area that would take two competitor wipes to complete effectively.
How they tested it.
In a recent Dental Advisor study² on surface disinfectant wipes, OPTIM OS1 outperformed the other brands, including a leading quats-alcohol wipe. Not only did it remain effective for its full 1-minute contact time, but it also covered a much larger surface area than the competitor wipes.
To test the wipes, researchers used a 12.5-square-foot table divided into four sections. Each wipe was used to wipe down one quarter section. Researchers then waited for the kill time to elapse before moving to the next section with the same wipe. OPTIM OS1 was able to effectively clean and disinfect two times more surface area than the leading quats-alcohol-based wipe.
VistaPure AutoFill
VistaPure’s patented AutoFill accessories replenish SciCan STATIM®and BRAVO™ autoclaves with distilled-quality water automatically — enabling truly hands-free convenience.
VistaPure AutoFill accessory kits work with all VistaPure systems and can be installed easily on any STATIM 2000/G4 or STATIM 5000/G4, or any BRAVO autoclave, in just a few minutes!
- No more purchasing and storing distilled water
- No more cycle-fault errors caused by forgetting to fill reservoirs
- No more spills while filling autoclaves manually
- No more staff time spent filling autoclaves = more time with patients
VistaPure AutoFill Installation
A 12-foot length of clear polyurethane tubing is already attached to the AutoFill manifold. If the desired distance between the connection to the VistaPure and the autoclave is greater than 12 feet, simply order a longer length of the clear polyurethane tubing, as the distance from the VistaPure to the autoclave is not limited, except by the feed tubing.
Installing AutoFill on a STATIM
The VistaPure AutoFill for STATIM device (S3020) can be installed on any STATIM 2000/G4 or STATIM 5000/G4 autoclave as follows:
https://www.scican.com/us/media/water-management/SD-491_US_EN%20R1_Autofill_Sell%20Sheet_20160805_PRNT.pdfInstalling AutoFill on a BRAVO
The VistaPure AutoFill for BRAVO device (S3030) can be installed on any model BRAVO autoclave.
In order to connect the VistaPure AutoFill to the BRAVO, one of the two tanks that come with the BRAVO must be selected as a “relay tank” since the BRAVO system uses a suction-lift pump to fill its reservoir when in its automatic-filling mode. Note that the relay tank must be located within 6 feet of the BRAVO unit, due to the suction-lift capacity of the BRAVO pump.
Connecting to a StatClave G4
![AquaStat Distiller [Replaced by LP90, LP80, DP860 or VistaPure]](https://i0.wp.com/d2j6dbq0eux0bg.cloudfront.net/images/226067/469791773.jpg?resize=238%2C400&quality=89&ssl=1 "AquaStat Distiller [Replaced by LP90, LP80, DP860 or VistaPure]")
