Stop throwing away money on wipes
Tell us about your studio and we’ll show you how much you can save.
Here is a calculator for how much you can save with OPTIM OS1 wipes
Save Money
Offices using Quats-alcohol-based wipes that switch to OPTIM OS1 can save over $2,000 per year on average.
Shorten Turn Over Time
A hospital-grade cleaner-disinfectant with 60-second kill times for the toughest viruses, bacteria, and yeast, and 45 seconds for TB.
Reduce Wipe Waste
Wipe down the same surface area that would take two competitor wipes to complete effectively.
How they tested it.
In a recent Dental Advisor study² on surface disinfectant wipes, OPTIM OS1 outperformed the other brands, including a leading quats-alcohol wipe. Not only did it remain effective for its full 1-minute contact time, but it also covered a much larger surface area than the competitor wipes.
To test the wipes, researchers used a 12.5-square-foot table divided into four sections. Each wipe was used to wipe down one quarter section. Researchers then waited for the kill time to elapse before moving to the next section with the same wipe. OPTIM OS1 was able to effectively clean and disinfect two times more surface area than the leading quats-alcohol-based wipe.
We will repair your STATIM or other SciCan equipment
For your SciCan product repair we will need the following details: your serial number which should be on the back of the unit, and a description of the issues noted such as cycle fault numbers, sounds or visible damage.
With this information we will provide you with a return authorization number and the best shipping address for where to send the equipment.
*The minimum estimate fee is $150 in case the estimate is refused and equipment is to be returned unrepaired or destroyed/recycled.
**ONE SERIAL NUMBER & PO PER REQUEST (PO NUMBER CANNOT BE DUPLICATED FOR MULTIPLE UNITS)
This Repair Form is for Equipment only – If you are sending in a Handpiece, please fill out the “Handpiece Repair Form".
Please note, the RA number must be on the outside of the box.
Any machines returned to SciCan without an RA number will be returned.
Shipping the Statim Unit
- Place a water container below the unit.
- Using the drain tube (see Section 3.5 Priming the Statim Pump, Figure 6 in the manual) empty the contents of the reservoir into the water container.
- Remove any remaining water from the reservoir with a non-linting, absorbent towel.
- Screw-in the three leveler feet found underneath the unit.
- Repack the unit in the original packing materials and include all accessories originally included with the unit.
- Specify heated and insured shipping.