STAT-DRI Plus Drying / Rinse Agent For faster drying

Stat-Dri Plus

STAT-DRI Plus Drying / Rinse Agent For faster drying

For faster drying and seal lubrication coat the STATIM Cassette: After cleaning and drying the cassette, treat the interior surfaces with STAT-DRI Plus.
Add to the rinse aid dispenser on your HYDRIM instrument washer for effective drying results. Use StatDri Plus Drying agent for dramatically improved STATIM, BRAVO and HYDRIM drying and to extend the life of your STATIM seal.

You’ll notice the difference on your first cycle!

Stat-Dri Use Protocol

STATIM 2000/5000 Operator’s Manual 95-108027 Rev 5.0.
Copyright 2008 SciCan Ltd . All rights reserved.

3.9 Preparing Unit for Use

Once the unit is installed and before any instruments are sterilized, run two Wrapped Cycles (see Section 4.8 Statim 2000 – Running a Cycle and 4.10 Statim 5000 – Running a Cycle). Remove the cassette once it has cooled. Clean the top (lid) and bottom (tray) sections using a soft cloth to wipe the inside surfaces and then rinse thoroughly with tap water. Once the cassette is clean and dry, coat the inside surfaces with STAT-DRI.

STAT-DRI

Treatment of the interior surfaces of the cassette with the STAT-DRI drying agent, provided with your unit, will enhance the drying process. (Replacement bottles are available from SciCan, order number 2OZPLUS, 8OZPLUST, 32OZPLUS).

4.3 Statim 5000 — STAT-DRI Plates

The Statim 5000 cassette uses STAT-DRI plates to enhance the drying process for wrapped instruments. The adjustable plates are designed for the unwrapped instruments rack and eliminate the need for a separate wrapped instrument rack. Up to ten plates can be arranged along the length of the rack. Each unit is shipped with five STAT-DRI plates. Additional plates may be ordered from SciCan (SciCan part number 01-103935).

To install and adjust a STAT-DRI plate, follow these steps:

  1. Hold a plate over the desired position, tilted slightly forward with the tabs down.
  2. Insert the tabs between the mesh of the unwrapped instrument rack.
  3. Each tab has an elongated slot. Slide the plate until the wire is at the end of each slot.
  4. Release the plate to the resting position.
  5. Prepare and load instruments for sterilization.

5.1 Cleaning the Cassette

Keeping the Statim cassette clean is good clinical practice and assists in the function of the unit. SciCan recommends that the interior surface be cleaned at least once a week. Use dishwashing soap or a mild detergent that does not contain chlorine. Scrub the inside of the cassette with a cleaning pad designed for use with Teflon™ coated surfaces. After scouring, rinse thoroughly with water to remove all traces of the detergent. Cleaning the inside of your cassette is very important if you regularly sterilize lubricated instruments. Coating the entire inside surface with STAT-DRI / STAT-DRI PLUS drying agent induces water to form an even coat on the inside surface, without beading. The water in contact with the hot cassette surfaces also evaporates much more efficiently. Spotting is minimized and instruments dry much better. STAT-DRI / STAT-DRI PLUS should be applied every 10 cycles, and after every cassette cleaning.

Stat-Dri vs. Jet-Dry

Stat-Dri Plus is specially formulated to protect stainless steel instruments. All microbiological sterilization efficacy testing has been done using Stat-Dri. We have not conducted such tests using Jet-Dry, and therefore cannot provide any data to support using any Jet-Dry products as an alternative.

Keep in mind there are several flavours of Jet-Dry on the market, including Jet-Dry with baking soda, Jet-Dry Turbo-Dry, etc. all of which have slightly different chemical composition. As a result, customers who choose to use Jet-Dry instead of Stat-Dri do so at their ‘own risk’.

Courtesy of Statim.us

 

Water Distiller 5 gallon automatic system
+3

Water Distiller 5 gallon automatic system

DP-850
$1,995
*Free shipping to 48 US States!
In stock
1
Product Details
Brand: Pure Scientific

Treat yourself to our deluxe automatic stainless steel water distiller!

Premium Steam Distillation Appliance

The DP850 Automatic Laboratory Water Distiller is an extremely reliable and convenient appliance for Piercing and Tattoo studios and dental offices that produces up to 7 gallons of steam distilled water each day and has a 5 gallon storage tank. Put this appliance on a shelf, or purchase the optional stand and simply dispense the water from the from of the appliance when you need it.

  • Forget about buying expensive distilled water.
  • Make your own from any tap water, even spring fed sources!
  • Makes high-purity distilled water <5ppm TDS that can perfectly fill any of our STATIM, StatClave, and Bravo autoclaves.
  • Simple maintenance.
  • High-quality, stainless steel construction.

QUALITY CONSTRUCTION

The DP850 is constructed of stainless steel and top-quality components to provide years of dependable service.

AN EXCELLENT INVESTMENT

When comparing the DP850 to competitive distillers, which have a very short lifespan, or bottled water it’s clear that the DP850 is an excellent investment that will pay you back many times over.

AUTOMATIC OPERATION

The DP850 automatically produces distilled water and stores it in a 5 gallon internal stainless steel storage tank so you’ll never run out of distilled water. Just dispense distilled water whenever it’s needed.

FAR SUPERIOR TO PLASTIC DISTILLERS

The DP850 is superior to competitive distillers in design and construction. It’s automatic operation offers more convenience and superior water quality.

CONSISTENT PURITY

The DP850 provides unsurpassed purity on a consistent basis.

LONG LIFESPAN

The DP850 is a heavy duty appliance and is built to-last. The DP850 has a proven track record and a 5-year limited warranty.

FREE DRINKING WATER

Save even more money each month by filling up bottles of drinking water with fresh, great-tasting steam-distilled water.

SIMPLE INSTALLATION

The DP850 is very simple to install. It just requires a 1/4” line into the machine. No drain line is required.

EASY MAINTENANCE

The DP850 requires very little maintenance.

SPECIFICATIONS

  • width 21” (53.3 cm)
  • depth 18” (45.7 cm)
  • height 16.5” (41.9 cm)
  • height (w/floor stand) 34.5” (87.6 cm)
  • storage capacity approx. 5 gal.
  • daily production 7 gallons
  • total wattage 1,100 watts
  • current draw (240V) 4.5 amps
  • current draw (120V) 9 amps
  • dry weight 48 lbs. (18.9 kg)
  • Specifications and product list may be subject to change without notice.

Take Control of Your Distilled Water

The DP850 allows you to take control of your own supply of pure, steam-distilled water. No more running out of distilled water, last minute trips to the store and no more of the hassle or wasted space of bottled water or finding out that the water is not pure enough for your STATIM.

  • Automatic operation.
  • Produces plenty of steam-distilled water for small to large Piercing and Tattoo studios.
  • Simple installation.
  • Long Lifespan.

    • Our automatic water distiller is a heavy duty appliance and is built-to-last. It has a proven track record and a 5-year limited warranty for the stainless steel parts, 1 year for the electrical parts.

    Self Sterilizing

    Steam sterilization is a method of decontamination for your distiller and storage tank. It can be done by allowing the unit to operate without the fan, thus allowing steam to pass through the system and into the storage tank.

    Automatic Operation

    The DP850 automatically produces plenty of steam-distilled water each day. Simply dispense the distilled water directly from the front of the DP850 whenever it is needed.

    Over 50 Years of Trust

    For 50 years, dentists, piercers and tattooists around the world have used our premium steam distillation appliances (under different brand names) to ensure that they are using the highest quality water at all times.

    Modern Autoclaves need high purity water

    Statim, StatClave and Bravo autoclaves require pure steam distilled water and will reject impure water. Use less pure water and their lifespan could be shortened. Piercing and Tattoo studios and dentists should use only pure, steam-distilled water in their autoclaves. Distill and test it yourself with your own TDS meter to below 5ppm TDS.

    Made with pride in Lincoln Nebraska, USA.

    Optional Accessories: Save Heating Elements and Hassles!

    Add an in-line Water Softener

    This pretreatment accessory softens the feed water before it is distilled to reduce residue build-up and scaling in the boiling chamber. Unlike other softeners the Softener Cartridge Kit requires no regeneration as the cartridge is simply discarded and replaced. To calculate the number of gallons that can be softened before the cartridge needs to be replaced you simply divide the capacity of the cartridge by the hardness of the water and divide by the maximum capacity of the distiller.

    4500-Grain Softener Cartridge System

    Features:

    • 4500-grain removal capacity
    • Fits in standard 20” big blue filter housing
    • In-line installation to ¼” tubing and quick connect fittings.
    • Replaceable cartridge
    • No regeneration

    System Includes:

    • 20” 4500-grain softener cartridge
    • Filter housing
    • Bracket
    • Fittings

    Example:

    • Hardness = 10 grains per gallon
    • Cartridge Capacity = 4500 grains
    • Distiller Capacity = 10 gallons per day
    • 4500 grains / 10 grains per gallon = 450 gallons that can be treated by one cartridge
    • 450 gallons / 10 gallons per day distiller capacity = 45 days before cartridge needs to be changed

      *Calculating by distiller’s maximum capacity gives the shortest period. Use an estimation of the studio’s actual distilled water usage when doing the calculation
    Save this product for later
    Display prices in: USD